Embedded Intel Atom® Processors
Technological Conversations about Intel Atom® Hardware, Software, Firmware, Graphics

Enabling ECC with E3845

DRice3
Beginner
1,518 Views

I am trying to enable ECC on a derivative E3845 PCB using the BCT/coreboot solution for the firmware. It works for the most part, but I am not seeing any indication that ECC is enabled. Do I need to change any settings in BCT other than "Bakersport-ECC" and/or "DDR3ECC"? Do I need to enable CH1?

0 Kudos
1 Reply
CarlosAM_INTEL
Moderator
462 Views

Hello drice,

Thank you for contacting the Intel Embedded Community.

The information that may help you is stated in the note of the step 4.a in section 5.0; on page 13 of the http://www.intel.com/content/dam/www/public/us/en/documents/guides/atom-e3800-crb-guide.pdf Intel(R) Atom(TM) Processor E3800 Product Family Customer Reference Board (CRB) Platform Guide.

It is important to let you know that the Coreboot consultations should be further answered through the emails listed at the http://www.coreboot.org/mailman/listinfo/coreboot coreboot Info Page.

Please let us know if this information is useful to you.

Best Regards,

Carlos_A.

0 Kudos
Reply