- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone
I have an embedded SR40B HM370 Chipset motherboard. I have a problem on the motherboard I can't solve.
Now the motherboard power steps are as follows.
+3VLP OK
EC_ON OK
+5VALW OK
ON/OFFBTN# OK
+3VALW OK
+1.05VALW OK
EC_RSMRST# OK
PBTN_OUT# OK
The above steps are ok. All voltages are correct. But the motherboard will not work because there are no steps below.
My question is: Do these three steps below occur after the hardware (ram, cpu, etc) check or after the software (bios, EC firmware, etc.) check?
PM_SLP_S4# NO
PM_SLP_S3# NO
SYSON NO
After which control step these occur.
Thanks.
Best Regards.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @GokcanHalil ,
Thank you for contacting Intel Embedded Community.
We sent an email to the address associated with this account with information that may help you.
Best regards,
Jaime L.

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page