Can I connect the X4DACBL3 to the HP 5412zl module j9536a? - Intel Community

Ethernet Products

Determine ramifications of Intel® Ethernet products and technologies

Can I connect the X4DACBL3 to the HP 5412zl module j9536a?

1,527 Views

I have install a XL710-QDA2 on a supermicro server and have setup the NIC with 4x10 through the EFI utlity QCU.

I would like to connect the server to my HP 5412zl switch, but so far no luck just "port status = down"

So my question is:

Can I connect the X4DACBL3 to the HP 5412zl module j9536a?

Link Copied

2 Replies

492 Views

Hi tzidore,

Please contact HP if there's needed configuration to establish connection with similar setup. I'll also check internally if there's known report regarding your issue and will update this thread as soon as possible.

regards,

Vince

Copy link

492 Views

Hi tzidore,

I've noticed you've reported your issue thru our web portal and already received response.

You may also look into your switch software version as mentioned in HP article( page 2) to have at least version 15.02 or higher (1m to 7m), 15.05 (10m to 15m) for SFP+ connection

HP article Link below:

http://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=4293022&docLocale=en_US&docId=emr_na-c02604897

regards,

Vince

Copy link

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.