I218-V and I219-V LED Status

[DShar9]

I am currently using two separate boards with integrated I218-V and I219-V network adapters, hard wired through CAT6 cables to a switch.

When the I219-V machine is in S4/S5 sleep the link LED on the adapter and switch turn off.

When the I218-V machine is in S4/S5 sleep the link LED on the adapter and switch remain on.

Both adapters are configured with WOL disabled in the UEFI and also windows. The I218-V also continues showing a link if ErP is enabled. For my setup it is important to be able to tell the machines status by the light on the switch which is located in a separate room.

Any suggestions on why the two adapters are behaving differently, and how to configure them to behave in the same way?

[st4]

Hi ds4130,

Thank you for the post. It is recommended to contact the board vendor which integrated the ethernet controller on the system.

rgds,

wb