- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I created a custom board for Jetson TX2 with i210. I successfully flashed iNVM using EEPROM access tool. But the device is not detected by ethernet driver in Jetson TX2. igb driver is showing mac address error. When I connected the sam jetson to a development board by auvidea it is working fine. The development board hass both iNVM and flash. I haven't provided a flash for i210 in the design. Is there any possibility that any connection is missing or additional driver is required for this?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Dileep,
Thank you for posting in Intel Ethernet Communities and we sincerely apologize for the delay in our response.
We noticed that you have submitted a ticket thru your local support group and requested to close the ticket. With this, please be informed that we will now proceed with closure as well. If you need any additional information, please submit a new question as this thread will no longer being monitored
May you have an amazing day ahead!
Best regards,
Crisselle C
Intel Customer Support
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Dileep,
Thank you for posting in Intel Ethernet Communities and we sincerely apologize for the delay in our response.
We noticed that you have submitted a ticket thru your local support group and requested to close the ticket. With this, please be informed that we will now proceed with closure as well. If you need any additional information, please submit a new question as this thread will no longer being monitored
May you have an amazing day ahead!
Best regards,
Crisselle C
Intel Customer Support
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page