Altera avst pcie enumeration using synopsys pci vip

[pdewanga]

Hi community team, 

I want to use the pci_vip from synopsys for my simulation tb setup along with Avalon-st as an endpoint .

My queries is weather we can use both the serial and pipe interface of vip to do the enumeration of av-st ?

If both the interface are supported by avst, then where should we define the  interface in avst pcie core.

Please Note: I don't want to use the simulation tb generated by qsys. I want to use the 3rd party pci_vip from synopsys.

Regards,

Piyush

[wchiah]

Hi,

Can I know which Intel FPGA device you are using ?

Regards,

Wincent_Intel

[pdewanga]

Hi, 

I am using the Stratix10M Fpga 

[1SG10MHN3F74C2LG ]

Regards, 

Piyush

[wchiah]

Hi,

To be honest, I am not familiar with Synopsys tools as I am focusing on Intel PCIe IP.

If your question is about Stratix 10 AVST can support Serial Pipe or not, then you can refer on the user guide.

https://www.intel.com/content/www/us/en/docs/programmable/683111/21-1/introduction.html

The pipe interface is available under simulation only where you can refer under Section 3.15

While the information about Serial and PIPE you can refer under Section 5.2.1

Hope this answer your question, let me know if any further clarification is needed.

Regards,

Wei Chuan

[pdewanga]

Hi Wei Chuan, 

My question is little generic only - can we use the serial and pipe interface both in simulation for enumeration ? leave the synopsys vip.

Attaching the figure showing pipe and serial interface.  

[wchiah]

Hi,

As mention in the user guide, it support simulation only.

Hope this clarified, let me know if futher clarification is needed.

Regards,

Wincent_Intel

[wchiah]

Hi,

I wish to follow up with you about this case.

Do you have any further questions on this matter ?

​​​​​​​Else I would like to have your permission to close this forum ticket

Regards,

Wincent_Intel

[wchiah]

Hi,

We do not receive any response from you to the previous answer that I provided.

Hence, This thread will be transitioned to community support.

If you have a new question, feel free to open a new thread to get support from Intel experts.

Otherwise, the community users will continue to help you on this thread. Thank you

If you feel your support experience was less than a 9 or 10,

please allow me to correct it before closing or please let me know the cause so that I may improve your future support experience.

Regards,

Wincent_Intel