Any reference design of ALT2GXP transceiver ip..........................

[Altera_Forum]

Hi, 

 I hope anyone will reply to this..... I wanted a reference design of the ALT2GXB transceiver....where can i find it,,,, if anyone who has worked pls provide me with the reference design... i wanted help in the pin assignment and cal_blk_clk input's...............  It will be very much helpfull for my project so that i can refer some important details from it..........pls........reply

[Altera_Forum]

I'm not sure how different the ALT2GX component is relative to the Stratix IV GX ALTGX components, however, the following application note is pretty good: 

 http://www.altera.com/literature/an/an553.pdf  The cal_blk_clk on the Stratix IV has its timing requirements specified in the handbook, so the Stratix II GX should have it specified too. Something around 50MHz should be fine.  Cheers, Dave

[Altera_Forum]

Thank you very much Sir for the reply, 

 I was waiting for the reply.....  I will have a look at the pdf.... I am using the Stratix II GX PCie board.......for high speed serial communication

[Altera_Forum]

You can find example designs on Altera's FTP site: ftp://ftp.altera.com/outgoing/siigx_demo_designs/ (ftp://ftp.altera.com/outgoing/siigx_demo_designs/) 

I got it from our FAE for Belgium: Armin Faems - Arrow Central Europe GmbH

[Altera_Forum]

--- Quote Start ---  You can find example designs on Altera's FTP site: ftp://ftp.altera.com/outgoing/siigx_demo_designs/ I got it from our FAE for Belgium: Armin Faems - Arrow Central Europe GmbH  --- Quote End ---     --- Quote Start ---  You can find example designs on Altera's FTP site: ftp://ftp.altera.com/outgoing/siigx_demo_designs/ I got it from our FAE for Belgium: Armin Faems - Arrow Central Europe GmbH  --- Quote End ---      Thank you very much Sir, Its very useful link :):):):)