- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am unsure what is the accurate title of my question.
I am a bit lost. So I'm working on a project that requires me to take image from D5M camera, and then the image will be processed by a convolution algorithm designed by myself and then the output will be through VGA. I have created the design by using DSP Builder and then tried hardware-in-a-loop and it's working fine, but currently the input image was from matlab. All I need to do is to change the input image, from matlab to the D5M camera. But I am not sure how to integrate my design with the camera. Do I have to change my design entirely or can I just like communicate the IP of the camera with my design? Can anyone enlighten me?Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bump. Please help me.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
If you have any knowledge about d5m module interfacing with DE2 board, please help.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page