FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6359 Discussions

DDR2 RAM on DB4CGX15

Altera_Forum
Honored Contributor II
‎09-27-2010 10:59 AM
966 Views

Hi, 

 

I have a problem with the DB4CGX15 Borad and the implemented DDR2. In SOPC Builder I choosed the DDR2 SDRAM High Performance Controller. When I completed the SOPC System, gerneration was succesfull. When I go back in Quartus and compile I get an error massage: 

 

Error: The design contains 2 blocks of type "Embedded multiplier block" but the selected device EP4CGX15BF14C6 does not support such blocks 

 

From the datasheet I also know the EP4CGX15 has no embedded multipliers. So where can I pull them off? Or have I made another error? 

 

Thanks in advance!
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎09-27-2010 12:59 PM
269 Views

Hi again, 

 

finaly I found it by myself. The failure was done by myself too. I forgot to turn of the Hardware multiplier implementation in the nios2. So the error wasn´t a result of the DDR2 RAM Controller.
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.