- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I am having trouble connecting two phy's (88E1111) from the MAX 10 development kit to two TSE MAC's. The board has two PHY chips but, both of them are connected on the same MDIO and MDC pin.
As I want to send data from one TSE instance to a second TSE instance I will have 2 MDIO interfaces. So my questions is how can i make a switch between these 2 mdio interfaces, because only one TSE can be the master at once?
Any help is appreciated
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi MDehp,
Intel FPGA TSE IP can use one MAC to control 2 PHY with same MIDO interface.
You can refer to TSE IP user guide doc page 78 (table 34) for the configuration register detail.
Thanks.
Regards,
dlim

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page