- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Forum,
I've set up a testbench / simulation model in QSYS of a small system consisting only of a "Clock Source" and a "JTAG to Avalon Master Bridge" named j2a. The generated testbench added the appropriate BFMs to all Interfaces except for JTAG. j2a is configured to run in PLI-simulation mode. When I run modelsim, everything compiles fine. After that modelsim prints at the console, that it is waiting for a PLI client at 127.0.0.1 / Port 50000. Questions: How can I setup such a client? I guess the system console should do the trick, how can I setup the system console to connect to modelsim? Your help is much appreciated! jb123Link Copied
0 Replies

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page