FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
6673 Discussions

Marvell 88E1111 PHY question

Altera_Forum
Honored Contributor II
‎10-28-2010 02:43 AM
1,106 Views

I am using cycloneIII board with Marvell PHY RGMII interface. After searched around forum, I found suggestions that in order to receive frames successfully, the bit7 of mdio register 20 should be set to 1 (default is 0) to add delay 2ns to rx_clk. Is this always the case for Marvell 88E1111 PHY or it's board dependent? 

 

Thanks!
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎10-28-2010 07:10 AM
384 Views

No, it depends on how you specify the timing requirements on the FPGA side.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.