- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI
I have configured and implemented TSE (Tri speed Temac core) in RGMII mode with internal fifo options (1000Mbps) for the DE2_115 evaluation board (Cylone IV E device). This register configuration and clocks as per the TSE user guide. Simulations are also seems to be fine. But When i test on hardware (DE2_115 board), am able to see RGMII_in data in signal tap which is send by PC. But am not able to see MAC RCV output means on ff_rx_data and its control signals. Please give me suggestions if any one hasLink Copied
0 Replies

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page