FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6560 Discussions

TSE MAC IP Core Connection to SFP

RVadl
Beginner
‎09-06-2018 04:45 AM
1,229 Views

We have a system in which we are using Altera TSE MAC IPCore to interface our processor to PHY IC (DP83822). This PHY IC is connected to external devices over Copper medium. We are successful in establishing this communication.

But when we replace this copper medium with SFP module, we are facing issues with communication interrupts.

Is it correct to replace the copper medium directly with SFP on the same setup?

Are there any specific configurations in TSE MAC/processor that are required specifically for connecting SFP modules?

 

Thanks in advance

 

0 Kudos

Link Copied

1 Reply
MTwee
Beginner
‎09-06-2018 08:06 AM
549 Views

I geuss you need to find a way to configure the external phy to fiber mode instead of copper mode. Check at the data sheet how to set this mode (either by pins or writing a register)

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.