FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6424 Discussions

Using IP as .qxp file

SKon1
Novice
553 Views

Hello,

I have an old desgin implemented on a Cyclone III FPGA. This design uses a 3rd party IP in the form of an .qxp file.
I want to migrate the design to an Arria V FPGA.

Can I use the same .qxp file ?
Or do I have to request the IP vendor to re-synthesize it?

0 Kudos
3 Replies
RichardTanSY_Intel
530 Views

As mentioned in the KDB:

https://www.intel.com/content/www/us/en/support/programmable/articles/000075849.html

As the recipient of a .qxp file, you will need to ensure that your project targets the same device (or at least the same device family if the .qxp file does not include placement information), as specified by the sender.

 

So you will need to request the IP vendor to re-synthesize it as it is a different device family.

0 Kudos
RichardTanSY_Intel
505 Views

As mentioned in the KDB:

https://www.intel.com/content/www/us/en/support/programmable/articles/000075849.html

As the recipient of a .qxp file, you will need to ensure that your project targets the same device (or at least the same device family if the .qxp file does not include placement information), as specified by the sender.

 

So you will need to request the IP vendor to re-synthesize it as it is a different device family.


0 Kudos
RichardTanSY_Intel
499 Views

I have yet to receive any response from you but I believed that I have answered your question. 


With that, I will now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.


Best Regards,

Richard Tan


p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos. 



0 Kudos
Reply