FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
6343 Discussions

VIP SCALER II output data all zero

Altera_Forum
Honored Contributor II
949 Views

When I run the SCALER II with no control port, I use the bicubic way. And I have no .mif file 

The control packet can output correctly, but the video packet output is all zero. 

The valid, ready, sop and eop are output correctly. 

My datapath is as follows: deinterlace II --> CLIP --> SCALER II --> FRAME BUFFER 

Can anyone help me to solve this problem, thanks
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
208 Views

Hi Jiangsuren,  

 

You will get the zero video packet out in the simulation could be due to the *mif file is missing.  

Could you please copy the coefficient .*mif file to your simulation directory from the following folder?  

 

\synthesis\submodules\src_hdl 

 

Please also check if there is any warning or error message from the simulation.  

Best Regards, 

Terence 

 

(This message was posted on behalf of Intel Corporation)
0 Kudos
Altera_Forum
Honored Contributor II
208 Views

Thanks, it can run now

0 Kudos
Reply