FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
6673 Discussions

Video image processing suite in matlab/simulink directory?

Altera_Forum
Honored Contributor II
‎07-21-2009 03:24 PM
1,005 Views

Hi, What commands do I use in order to install the Video and Image processing megacores into Matlab/simulink. I did install the general megacores in simulink by using the "alt_dspbuilder_setup_megacore" command in matlab. However, the "Video and image processing suite" is in a different directory and I can not get these megacores into the simulink directory. 

 

Thank You 

Tom
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.