- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi advanced:
FPGA:cyclone iii(EP3C16Q240) Configuration devic:EPCS64 Configuration MODE:Active Serial i generate the *.pof by "Convert Programming File" tool, and *.pof contain two *.sof file. *.sof start address as below: first.sof start address :0x000000; second.sof start address:0x080000; i add the altremote IP into my project for configure second.sof, when i setting Control Register and Reconfigure. but after setting Control Register and Reconfigure, the FPGA is still working at first.sof. so how to slove? PS.attachment file is user_logic.v for control altremote IPLink Copied
0 Replies

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page