burst read and write DDR2 using altmemphy - Intel Community

FPGA Intellectual Property

PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP

burst read and write DDR2 using altmemphy

247 Views

1) Need forum admin to help, I can not post any reply on below topic.

2) answer to this topic:

I also attached code for you in the link.

3) correct one information, ddr2 ram is MT47H32M16CC-3.

https://community.intel.com/t5/FPGA-Intellectual-Property/burst-read-and-write-DDR2-using-altmemphy/m-p/1382679

Link Copied

1 Reply

231 Views

Hello,

According to the user guide, you can set the local_size either 2 or 1.

https://www.intel.com/content/dam/support/us/en/programmable/support-resources/bulk-container/pdfs/literature/ug/ug-ddr-ddr2-sdram-hp.pdf#page=68

If you still cannot post any reply, please try it with different browsers.

Let see if that can help you out.

Thanks,

Copy link

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.