FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
6673 Discussions

creating a channel using dsp builder or quartus

Altera_Forum
Honored Contributor II
‎06-06-2010 01:51 PM
1,005 Views

Hi everyone, 

 

I have some blocks implemented in simulink with dsp builder, and I have a vhdl code for each block, I want to connect them in order to create a channel; so is it better to do this with dsp builder and then exporting the project to quartus or making the channel on quartus. 

Thanks for the advice
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.