Hello,
I'm working on the transceivers of a Stratix IV GX230 FPGA in basic mode.
In the megawizard, I'm using the following settings:
-Protocol : Basic
-Subprotocol: None
-operation mode: Receiver and Transmitter
-Number of Channel : 1
-deserializer block width: Single
-Channel Width: 8
-Input clock : 160MHz
-Data rate :1600Mbps
-8b/10b mode : normal
I transmit the control data K28.5(0xBC) continuously.
The problem is the signal "tx_dataout" is unknown but not serialization data in simulation wave.
Attachments is my simulation wave.
regards
