- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i am facing a boring problem that i can get right simulation waveform. signal of sink_ready was reset to zero automatically then there is no result after timing simulation.
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i have already found the criticial point that there is a mistake at Figure 3–3 in the FFT MegaCore Function User Guide document.
the type of signal sink_ready is output !!!, so sink_ready have to be repalced by source_ready.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page