FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5985 Discussions

Arria 10 EMIF Toolkit Traffic generation

Chrisnu
New Contributor I
777 Views

Hi,

 

I am trying to run "Create Traffic generator connection" from EMIF toolkit and getting the following error:

 

Chrisnu_0-1701375503475.png

 

How do we enabled this to create traffic generator connection?

 

I am using . I am using Quartus Prime 20.1.

 

Regards,

 

Chris

Labels (1)
0 Kudos
1 Solution
AdzimZM_Intel
Employee
665 Views

Hi Chris,


I have checked in internal data for this related issue.

It's seem that the "Create Traffic Generator Connection" only works with Traffic Generator 2.0.

Try to avoid clicking on that because it's might cause the Tools to hang.


Regards,

Adzim


View solution in original post

0 Kudos
5 Replies
sstrell
Honored Contributor III
756 Views

Did you generate the example design?  I think you have to use the example design to connect to this with the EMIF toolkit.

0 Kudos
Chrisnu
New Contributor I
731 Views

Hi Sstrell,

 

Yes,I generated the example design and trying to run the traffic generator from EMIF tool.

 

Thanks,

0 Kudos
AdzimZM_Intel
Employee
666 Views

Hi Chris,


I have checked in internal data for this related issue.

It's seem that the "Create Traffic Generator Connection" only works with Traffic Generator 2.0.

Try to avoid clicking on that because it's might cause the Tools to hang.


Regards,

Adzim


0 Kudos
David32
New Contributor I
147 Views

Hi Adzim,

Since we are having a similar problem I am taking the liberty of continuing with a question.

Our custom board is using an Arria 10 SoC, and we are running Quartus Prime Pro 23.4.0

Question:

If I shouldn't click on "Create Traffic Generator Connection" then how am I supposed to actually run the TG?

Thanks

David

0 Kudos
sstrell
Honored Contributor III
116 Views

As noted, the option mentioned was for TG2, not the original traffic generator.  I think only the original TG is compatible with A10 so trying to enable that option to try to use TG2 instead would cause the issue.

0 Kudos
Reply