Can i interface external micro controller to MAX10M50 pins other than from bank 5 and bank 6 as EMIF controller.

[AnandRaj_S_Intel]

Hi @sab040887​ ,

Are you trying to say that you want to communicate between Micro-Controller and FPGA MAX10M50 using EMIF interface without using bank 5 and bank 6?

If Yes, Not possible without using bank 5 and bank 6 with EMIF interface.

However we can achive it by using SPI or I2C interface depending on your bandwidth to communicate with micro controller without using bank 5 and bank 6.

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/an/an485.pdf

Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

Regards

Anand

[sab040887]

Hello Anand ,

Thank You for reply. Could you recommend me any evaluation board for MAX10 with EMIF interface ? So i can connect external Micro controller. The Evaluation boards which i am using, it doesn't have PIN OUT for Bank 5 and 6.

Thank You.

Regards,

Subodh

[sab040887]

Hello Anand, I am Using MAX 10 as Client.

[AnandRaj_S_Intel]

​Hi Subodh,

Presently we don't have any board/Kit with pinout from Bank 5 &  6.

Regards

Anand