FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
6204 Discussions

Cyclone V KIT

Altera_Forum
Honored Contributor II
‎07-13-2016 11:37 AM
1,106 Views

Hello! 

 

I'm using Altera Cyclone V KIT and i have a ussue with Board Test System. In BTS i have error "No JTAG cable detected". In same time in Quartus i see complete JTAG Chain, that placed on the board, so i can tell, that the board, cable and drivers is ok. Also i checked Windows System Variables. I searched thru forum and find many alike problems, that solved with installation of propriate version of Quartus software. 

I'm using Windows 7 x64 and Quartus Prime Lite (v.16). 

Wich version of Quartus i must use and where can i find it, so it will be possible to work with BTS? 

 

Thanks in advance!
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎07-13-2016 06:52 PM
349 Views

It's been a while since I played with the BTS (for the Arria 10 SoC dev kit), but if I remember correctly there can be conflicts between tools competing for the JTAG cable. Make sure the Quartus programmer and/or SignalTap tools are shut down before you open the BTS. 

 

Hope that helps.
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.