- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I cannot have the VGA demonstrations correctly working. I can see the default image and the cursors, but if I try to use any else image created by the image converter (.dat, .txt ecc...) and load the file into SRAM and then configure the asynchronous port1 (also tried the other ports!) no correct imagers are shown; actually, only the created .txt file shows some portions of the image, but not correctly. Anyone have the same problem? Tx JohnLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page