- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am following the manual from the link
Link1- https://www.terasic.com.tw/cgi-bin/page/archive.pl?Language=English&CategoryNo=205&No=1046&PartNo=4
for this-"BSP(Board Support Package) for Intel FPGA SDK OpenCL 18.1"
according to the manual i require Quartas standard edition for running Open CL and create a folder in the installation location of it
but the shown image in the manual has folders which are related to Quartas pro, which dosent support the Open Cl
Please Guide me further
Thanks
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Which image did you point out ? Please let me know the figure number.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
File name -DE10_Nano_OpenCL_18.1.pdf , Page -12,Figure 2-1- Location of "D;\intelFPGA\18.1\hld\board\terasic" Folder
the path is for Quartas 18.1 pro , but the open CL here dosent support the pro edition of Quartas it supports only the Standard edition .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The default root path of current standard version is D\intelFPGA and that of pro version is D\intelFPGA_pro. Additionally, the directory hierarchy under root is same.
Also, if the directory was for pro version, there would be a10_ref and s10gx(not c5soc/s5_ref).
Thus, I think the path(D;\intelFPGA\18.1\hld\board\terasic) is correct.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page