- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you kindly give more information about the your connection ? Are you interfacing through processor GPIO ? Did you get chance to check with Oscope to make sure you are not getting data into the LCD ?
Can you share the code as well ?
I would like to ask whether you interfaced with FPGA or HPS IO ? I assumed it is HPS .Kindly confrim
Thank you,
Regards,
Sree
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Provided link below includes my code for DE0-Nano board.
(https://drive.google.com/open?id=195ww0rgXYDDwsnmXfKHR2jM0ZkdN3aSb)
I'm working on (http://www.terasic.com.tw/cgi-bin/page/archive.pl?Language=English&No=593) this board. Same code is working with DE2i-150 Development board. What are possible reasons to not obtaining the characters? Below is output image.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
sorry for very late response, Didnt terasic dont have the example RTL for the same ? it also depends on the RTL and also I see hw you wired it and connected via breadboard.
Too many variable to assume without further data on myside :(.
Thank you ,
Regards,
Sree

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page