SoC EDC 18.1 Preloader issue

[Naresh9812]

Hi,

I am using Terasic TSOM module(Cyclone V SoC FPGA) with Based board.
I am trying to run bare metal application from SD card using below boot method.

image498×119 20.9 KB

I have prepared SD card to boot preloader according to procedure explained in one of the Rocketboards page.

I can successfully boot bare metal application using prebuilt preloader image(\linux-sockit-gsrd-16.0-bin.tar\linux-sockit-gsrd-16.0-bin\preloader-mkpimage.bin) from GSRD v16.0 release.
But I am not able to boot the board with either prebuilt preloader image available in SoC EDS 18.1
installation(C:\intelFPGA\18.1\embedded\examples\hardware\cv_soc_devkit_ghrd\software\preloader\preloader-mkpimage.bin) or bsp-editor generated generated image(\cv_soc_devkit_ghrd\software\spl_bsp\preloader-mkpimage.bin).
Did anyone faced similar issue ? If yes, then how did you fix it ?

I have to change default preloader configuration through Platform Designer for hardware specific changes. It would be nice if someone can share their working preloader/u-boot project.
Where can I find GHRD v16.0 preloader/u-boot project(same folder structure like SoC EDS installation) ?

Best Regards,
Naresh

[Jeet14]

Hi Naresh,

You can get the older GSRD and GHRD from the below link.

https://releases.rocketboards.org/

https://releases.rocketboards.org/2018.10/gsrd/

Regards

Tiwari

[Jeet14]

Hi,

Please let me know if you have any question on this.

Regards

Tiwari

[Jeet14]

As we do not receive any response from you on the previous question/reply/answer that we have provided. Please login to ‘https://supporttickets.intel.com/s/?language=en_US’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.