Stratix 10: move data through the HPS SDRAM controller using the F2H AXI bridge.

[ap_mercy]

Hello, I'm trying to master data from the FPGA to SDRAM.  Which base address should I write to?

If there are examples out there I can use please link them. I can't find any.

[EricMunYew_C_Intel]

You can find the base address of the FPGA-to-SDRAM bridge in your Platform Designer.

[ap_mercy]

---

@EricMunYew_C_Intel wrote:

You can find the base address of the FPGA-to-SDRAM bridge in your Platform Designer.

---

@EricMunYew_C_Intel How can i confirm the bridge for FPGA-to_sdram bridge is enabled in the HPS?

[EricMunYew_C_Intel]

The F2SDRAM bridge can be enabled in your Platform Designer, you may refer to the attached.

[EricMunYew_C_Intel]

I’m glad that your question has been addressed, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.