Trouble connecting DE0-Nano board to computer for programming.

[LWrig3]

I have a DE0-Nano board with a Cyclone V FPGA. I am trying to program it using Quartus 2, but I cannot communicate with the board over my Altera Blaster cable. I have installed the correct driver software for the Altera cable, and I have tried using auto detect on the board to find it in Quartus, but nothing has worked. What am I missing? Thanks.

[Vicky1]

Hi,

I have a DE0-Nano board with a Cyclone V FPGA. I am trying to program --- If you are using DE0- Nano-Soc Board then refer chapter 3 from below user manual for board settings & configuration mode,

https://www.terasic.com.tw/attachment/archive/941/DE0-Nano-SoC_User_manual_rev.D0.pdf

In case of usb blaster perform device driver update using below user guide,

https://www.intel.com/content/www/us/en/programmable/documentation/nfa1418282998564.html

Do visual check of board, clean with care also provide screenshot of programmer & errors.

Regards,

Vicky

[Vicky1]

Hi,

"Do visual check of board, clean with care also provide screenshot of programmer & errors." ---- please provide screenshot of programmer after performing 'Auto Detect'.

You can refer the 'Debugging JTAG Chain Integrity' Intel online training as well,

https://www.intel.com/content/www/us/en/programmable/support/training/course/odjtag1110.html

Regards,

Vicky

[Vicky1]

Hi,

May I know any update? or

Should I consider that case to be closed?

Regards,

Vicky