FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5288 Discussions

Trouble connecting DE0-Nano board to computer for programming.

LWrig3
Beginner
361 Views

I have a DE0-Nano board with a Cyclone V FPGA. I am trying to program it using Quartus 2, but I cannot communicate with the board over my Altera Blaster cable. I have installed the correct driver software for the Altera cable, and I have tried using auto detect on the board to find it in Quartus, but nothing has worked. What am I missing? Thanks.

0 Kudos
3 Replies
Vicky1
Employee
107 Views

Hi,

I have a DE0-Nano board with a Cyclone V FPGA. I am trying to program --- If you are using DE0- Nano-Soc Board then refer chapter 3 from below user manual for board settings & configuration mode,

https://www.terasic.com.tw/attachment/archive/941/DE0-Nano-SoC_User_manual_rev.D0.pdf

In case of usb blaster perform device driver update using below user guide,

https://www.intel.com/content/www/us/en/programmable/documentation/nfa1418282998564.html

Do visual check of board, clean with care also provide screenshot of programmer & errors.

Regards,

Vicky

 

Vicky1
Employee
107 Views

Hi,

"Do visual check of board, clean with care also provide screenshot of programmer & errors." ---- please provide screenshot of programmer after performing 'Auto Detect'.

You can refer the 'Debugging JTAG Chain Integrity' Intel online training as well,

https://www.intel.com/content/www/us/en/programmable/support/training/course/odjtag1110.html

Regards,

Vicky

 

Vicky1
Employee
107 Views

Hi,

May I know any update? or

Should I consider that case to be closed?

Regards,

Vicky

Reply