Hi
First, arria 10 writes the application image through the ASMI IP, and then loads the application image through the remote_update IP. Why must the board be powered off to succeed, but the reset does not work?
Link Copied
Hi CB Xu,
Sorry for the late response.
I am not sure what you meant by reset here.
Please refer following guide:
Remote Update Intel® FPGA IP User Guide
Search for RU_RECONFIG in the document and follow steps mentioned in section 1.2.1.1.1 for the new configuration to take effect.
Regards.
For more complete information about compiler optimizations, see our Optimization Notice.