Graphics
Intel® graphics drivers and software, compatibility, troubleshooting, performance, and optimization
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
22737 Discussions

ehci controller handoff

idata
Employee
‎12-06-2010 06:18 PM
1,794 Views

Dear sir,

 

When I write EHCI driver for my small OS, I encountered a problem. When cold booting up from a USB disk2.0, the EHCI handoff fails because that both OS-owner bit and the BIOS-owner bit are set already. The HCCPARAMS value is 0x1010001. But it will be OK at warm boot up and I can operate USB disk at about 3.4M/s data rate. If I don't handle this and use its 4 companions, all is OK. The machine is good and Windows Xp can boot normally. Why does this happen and how could I survive from this situation. Thank you for advance.

The chipset is Intel (R ) 82801G(ICH7 Family)

 

CPU is Intel (R ) Pentium(R ) Dual E2160 @1.8GHz

What about other chips?

0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.