- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have AMT system booted to DOS mode(Command prompt - text data only). AMT version is 7.0
Now using Intel commander tool., connected to SOL using Remote Control -> Take control and connected to SOL mode It's showing blank screen only. Actually AMT system has dos command prompt Since it's a text screen it should get redirected, but not redirected text data. Anyone explain about this?
If i use remote reboot option in Intel commander tool, AMT system restarts and able to see post messages, text data in SOL. So do we need to reset system to see text console data like DOS OS
If AMT system is in BIOS page and connected to SOL using Intel commander tool and it's showing blank screen only and not BIOS screen
Thanks,
Mani
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'm dealing with a similar scenario. In my case, the AMT system may be sitting at a pre-boot prompt (like the one in the attached image) and I need to refresh when connected via SOL in order to obtain the prompt text and provide appropriate input. The system may have been at the prompt for some time before I connect.
Cheers,
Peter
![](/skins/images/45C6C2D737ED71F4C51F0145C8CB1E9C/responsive_peak/images/icon_anonymous_message.png)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page