Cannot send information to education registration support

[Josephg]

Re: Information Required: Intel® FPGA Academic Program Membership Application L-013561 ref : 00Q7V00001wsNV2UAM

Joseph Gabbay <josephg@mail.afeka.ac.il>	8:42 AM (9 minutes ago)
to FPGA

Hello

I am trying to answer but the email bounces back.

Here is another trial, let's hope this time it is OK,

Is this link good enough?

Joseph Gabbay | Afeka College - higher engineering studies in Tel Aviv

Attached pictures:

the first is taken from the WWW (you have a link),

The other is taken from Afeka's intranet system (may be limited to staff members as it requires authentication)

It is written in Hebrew, you can still verify my phone number as well...

Thank you

Regards,

Joseph Gabbay

[WeiHanT_Intel]

Hi Joseph,

Thanks for reaching out to Altera Community Forum. I would like to clarify a few things with you first, and see how can we be of help.

1. Were you trying to register through this URL? https://www.intel.com/content/www/us/en/secure/forms/developer/fpga-academic-enrollment/request.html
2. What error do you see? Or what problem do you faced? (detail elaboration would be greatly appreciated)
3. What is the email address that you've tried to contact that got bounced back?

Thanks,

Wei Han

[BoonBengT_Altera]

Hi Joseph,

Good day, just following up on the previous clarification.

By any chances did you managed to look into it?

Hope to hear from you soon.

Best Wishes

BB

[Josephg]

Hello BB, Wei Han,

I registered in this link and was redirected to another page:

https://www.intel.com/content/www/us/en/secure/forms/developer/fpga-academic-enrollment/request.html

Then I applied there for membership in the academic program.

I got response from fpga academic and was asked for details.

Information Required: Intel® FPGA Academic Program Membership Application L-013561 ref : 00Q7V00001wsNV2UAM

I tried to answer.

Unfortunately, any mail sent back to

fpga.academic@intel.com

is rejected.

Here is an error message that I get:

Address not found

"Your message wasn't delivered to fpga.academic@intel.com because the address couldn't be found or is unable to receive mail.

Trying my private gmail account rather than the academic account resulted in the same fault.

My membership of the Academic program was approved

Fwd: Intel® FPGA Academic Program: Membership Application L-013561

The next step is to demonstrate a stand-alone operation of the soft core NIOS II operation.

We have Terasic boards with Cyclone IV, Cyclone V and MAX10

Windows 10 machine

Re: Intel® FPGA Academic Program: Solutions Request [00128773] Created

What SW elements should be installed and How to get a license for NIOS II that can work as a stand-alone machine without JTAG tied to the board?

Thank you

Joseph G.

Best Regards,

Joseph

[BoonBengT_Altera]

Hi Joseph,

Apologies for the inconvenient cause, could you please try using this email below instead:

• FPGAUniversity <FPGAUniversity@intel.com>

There seems to be some confusion on the previous email.

Feedback noted and we would route this to the correct team to look into.

Hope that clarify.

Best Wishes

BB

[BoonBengT_Altera]

Hi Joseph,

Greetings, just checking in to see if there is any further doubts in regards to this matter.

Hope your doubts have been clarified.

Best Wishes

BB

[BoonBengT_Altera]

Hi Joseph,

Greetings, as we do not receive any further clarification/updates on the matter, hence would assume challenge are overcome. Please login to ‘https://supporttickets.intel.com’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. For new queries, please feel free to open a new thread and we will be right with you. Pleasure having you here.

Best Wishes

BB