Compilation Start won't work

[WNasa]

I'm working on a very simple logic gate diagram and want to compile it, but the program wont let me access that option. I don't have an FPGA board installed and was wondering if that would be the cause. I just need to find the Truth values of the diagram I've produced.

[CalvinJoaz_P_Intel]

Hi Wasi,

Good day.

You still can compile program without FPGA board installed.

What tool you're using? 

Refer link below if you're using Quartus tool.

ftp://ftp.intel.com/Pub/fpgaup/pub/Intel_Material/13.0/Tutorials/VHDL/Quartus_II_Introduction.pdf

ftp://ftp.intel.com/Pub/fpgaup/pub/Intel_Material/13.0/Tutorials/VHDL/Quartus_II_Simulation.pdf

Refer link below if you're using Modelsim Simulation.

ftp://ftp.intel.com/Pub/fpgaup/pub/Intel_Material/15.0/Tutorials/VHDL/Using_ModelSim.pdf

Hope this could be helpful.

Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

Thank you.