Issues with Sending Data to Microcontroller via SPI Using DE10-Lite Board

[Uday1012]

Hi Everyone

I am using Intel DE10 lite M50DAF484C7G from this i am trying to communicate with microcontroller just a basic communication sending some random data but its not sending any data so in that i am using Arduino pins for spi pins can i have just a basic code for simple spi master and arduino pins i am using are correct or should i use other pins

Thanks

@de10   @fpga 

[paveetirrasrie_Intel]

Hi,

We don't provide code support for 3rd party tool but I believe you may grab the code in Arduino website.

Regards,

Pavee

[FvM]

Hi,
some issues with the code

- bit_cnt == 8 (else condition) does never happen, need reg [3:0] bit_cnt;

- data_reg is only loaded once on POR, spi_master sends mosi == 0 constantly after first frame

- using always @(posedge sclk) is legal but might cause timing issues in a complexer design. Better use single system clock and modify
   clock-enable scheme respectively 

What's the indended SPI mode?

Regards
Frank

[paveetirrasrie_Intel]

Hello,

We didn't hear from you since last update. If you have a new question, feel free to open a new thread to get the support from Altera experts. 

Otherwise, the community users will continue to help you on this thread. 

Thank you.