Intel® FPGA University Program
University Program Material, Education Boards, and Laboratory Exercises
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
1238 Discussions

Pixel Buffer Back Buffer start address and resolution

Altera_Forum
Honored Contributor II
‎06-08-2014 01:20 PM
1,240 Views

Hi All 

 

I'm using the VIP Core to Display drawings on a monitor. 

Therefore, I'm using a Pixel Buffer with a resolution of 1280 x 960. 

 

On which value do I have to set the back buffer start address? 

Respectively, how large can I go with the resolution when I use the SRAM from the DE2-115 board? 

How is the relation between the resolution and the back buffer start address? 

 

Thank you for clarifying me these questions. 

 

Ben
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.