Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16727 Discussions

BlasterII driver installed but Quartus not detecting

Honored Contributor II

First time user familiarizing myself with Quartus using the SoCkit Cyclone Vand I have run into an issue programming the board. 


When I go into Programmer > Hardware Setup > Currently Selected Hardware, I do not get USB-BlasterII as an option. The only option I have is CV SoCKit [USB-1], which doesn't allow me to program the FPGA. I have gone into Device Manager (on Windows 10) and confirmed that the BlasterII drivers are installed. The two drivers appear under 'JTAG cables' labeled 'Altera USB-Blaster II (JTAG interface)' and 'Altera USB-Blaster II (System Console interface)'. 


Not sure how to troubleshoot this so any help would be appreciated. Thanks. 


EDIT: Resolved. The Blaster is part of the CV SoCKit device.
0 Kudos
0 Replies