- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am trying to program Altera Cyclone IV EP4CE6E22C8N using USB blaster but device is not detecting.
JTAG ( TCK, TDO, TDI, TMS) is connected well and having good continuity, checked using DMM.
Also all voltage levels are actual manner i.e
Vccio = 3.3V
Vint= 1.2V
Vaux= 2.5V
CE pin in connected to GND
Still not detecting.
I have another board with EP4CE10E22C8N which is working properly with USB blaster and Quartus programmer. New Board with new IC i.e EP4CE6E22C8N is not detecting.
Even I checked the waveforms on both boards, EP4CE10 is showing all JTAG waveforms but EP4CE6 is just showing JTAG Clock(TCK) what to do?
Please comment.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thank you for contacting Intel community.
That might be due to issue with USB Blaster. Kindly follow the workaround in KDB below (it is also applicable for USB Blaster):
Thanks.
Regards,
Aiman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page