EPM7128SLC84-15 - Quartus 2 13.0.1 SP1 Web - Programming Probem - no JTAG ID

Altera_Forum · ‎06-16-2014

Hello Altera-Profis,

I want to program a EPM7128SLC84-15 in a university project. I have already programmed it on a computer in the university.

Now I want to work with the Board on my own Computer.

But every time I want to load the Project on the chip I get following Message:

Error (209001): JTAG ID code specified in JEDEC STAPL Format File does not match any valid JTAG ID codes for device

I use following Quartus Version:

13.0.1 Build 232 06/12/2013 SP 1 SJ Web Edition

I can not match the right CPLD in the Programmer, so I think i need some JTAG ID codes for my CPLD or?

In the Programmer is the Device: EPM7128SL84.

So it is the wrong device which is deteced.

I hope you can help me.

best greets Lennart

Altera_Forum · ‎07-01-2014

No one can help me?

Altera_Forum · ‎07-01-2014

Have you installed the programming file?

Altera_Forum · ‎07-01-2014

What is the prgramming file exactly ?

I have found in the Compilation Repot in the Assembler Setting following Option:

"Generate a JEDEC STAPL Format File (.jam) for Target Device | Off"

Is that the wrong Setting? How can I change it?

Thank you for replying.

Altera_Forum · ‎07-01-2014

I meant the Quartus II file that tells it how to program the device.

Altera_Forum · ‎07-01-2014

Hm.. is this the .pof file?

In the Programmer, the .pof file is listed and there I checked "Program/Configure"

Are there more files to "install" ?

Altera_Forum · ‎07-01-2014

No. It's part of the installation.

Altera_Forum · ‎07-01-2014

Oh..yes I have installed all Device Familys during installation. But I am not sure because in the programmer I have no option for "EPM7128SLC84" but "EPM7128SL84". Although it works in university with the option " EPM7128SL84" too.