Getting Internal Error creating SignalProbe debug pins on Stratix III or CycloneIII

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

Getting Internal Error creating SignalProbe debug pins on Stratix III or CycloneIII

1,309 Views

When you use the Quartus II 7.0 to perform a SignalProbe compilation that targets either a Cyclone III device or a Stratix III device, you may receive an internal error.

The reason is that Quartus II 7.0 does not support programming/config file generation for Cyclone III and Stratix III devices. Programming/config file support and support for SignalProbe for Cyclone III and Stratix III devices will be supported post QII 7.0.

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.