How to reference a modport declared in generate block of interface?

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

How to reference a modport declared in generate block of interface?

1,610 Views

Consider an interface defined as following code:


interface test_interface# (
    parameter MODP_CNT = 3
);
    wire portsig_array;
    genvar iport;
    generate
        for (iport = 0; iport < MODP_CNT; iport++) begin:MODPORT_GEN
            wire portsig = portsig_array;
            modport testport(output portsig);
        end
    endgenerate
endinterface

When I want to reference the modport 'testport' defined above in a module port list, how to write the port list in target module?

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.