Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 Discussions

How to simulate NIOS II+ C Application in Modelsim-Altera

Altera_Forum
Honored Contributor II
1,437 Views

Hi everyone! 

I have just started study Computer architecture.I built a system by tool SoPC and make a application for it by Nios II SBT.But i have not a FPGA kit.So i choose "application Run as Modelsim-Altera",but a don't know how to start.Could you give me a piece of advice.Steps to simulate in modelsim
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
765 Views

I would start by going through the Nios II simulation appnote: 

 

http://www.altera.com/literature/an/an351.pdf 

http://www.altera.com/literature/an/an351_software_file.zip
0 Kudos
Reply