Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.

Incremental Compilation

Altera_Forum
Honored Contributor II
1,248 Views

Hello, I have a question.  

In my project, I set all modules to partitions. 

What does Quartus do when I set all modules even top level to post-fit, then I modify a child module and change connection between all modules? 

Does Quartus automatically chang all modules, which are modified to source-file then compile then change them back to post-fit after compilation?  

What's different between, if I keep all partition in post fit and change them to source file? 

Thanks !
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
509 Views

 

--- Quote Start ---  

Hello, I have a question.  

In my project, I set all modules to partitions. 

What does Quartus do when I set all modules even top level to post-fit, then I modify a child module and change connection between all modules? 

Does Quartus automatically chang all modules, which are modified to source-file then compile then change them back to post-fit after compilation?  

What's different between, if I keep all partition in post fit and change them to source file? 

Thanks ! 

--- Quote End ---  

 

 

If you set the partitions to "post-fit", Quartus will use the last fitting and ignore your changes. You just have to look at the Warnings, as an according statement will be given out.
0 Kudos
Reply