Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 Discussions

Lost connection to my Cyclone V SoC while programming the FPGA via quartus programmer

Altera_Forum
Honored Contributor II
‎07-26-2017 01:36 PM
1,716 Views

I am trying to run a new FPGA configuration to my board (Altera cyclone V SoC SX). When I programmed it via Quartus programmer I lost connection to it (from SSH). 

 

Have anyone seen this problem before?
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎08-01-2017 07:04 PM
886 Views

I suspect the design you configured into the FPGA drives the reset line into the HPS which caused the processor subsystem to reboot. If this is what is happening and you do not want this behavior you can disable the reset, I think it's called f2s_reset or something similar and recompile the design.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.