Possible to Control Quartus Prime 20.1 lite software from Command line?

[JLTWill]

I simply need to erase, program, verify and read success status for products in production  using the Quartus Prime and terasic blaster.  I'm able to do this using the GUI.  But is there command line support so I can automate it into a production test equipment?  I'm not the product developer.  The programming files will be supplied to me by our software department.  I just need to automate the programming of products in production.    I'm  having a hard time finding this information online.

Thanks

[sstrell · Accepted solution]

Everything is scriptable.  See Standard scripting guide at the bottom of the page here:

https://www.intel.com/content/www/us/en/programmable/products/design-software/fpga-design/quartus-prime/user-guides.html

[JLTWill]

Thanks, i will read through the info.

[JLTWill]

Thanks I was able to get it working after reading through the information.

[NurAiman_M_Intel]

Hi,

Thanks @sstrell for sharing the answer.

Regards,

Aiman