- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm attempting to install the Quartus II Linux version (free web edition) in RHEL6. As expected, I was kicked-out of the install script before completing the installation. Anyone ever try to run the Quartus II software in RHEL6? If so, what are the tricks to getting it to install correctly? Am I being a littel too adventurous here? Thanks.Link Copied
5 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
REL6 should be similar to Fedora 12, try searching the forum for Fedora install workarounds
can you paste the output of the installer here?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Right on. I just saw your thread in regards to deleting libX11.so.6 and running ./setup. Installation worked like a dream and the tools appear to be running fine in RHEL6.0. I'll post another message if I have any further problems.
Cheers.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
cool, that's about what i expected. it will probably take another release until REL6.0 is officially supported (in which case the libX11.so.6 issue should get fixed!)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
indeed, 10.1 installed and ran without a hitch on Fedora 13
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page