Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16916 Discussions

Signal Probe - Source node does not exist

tedh4ddv
New Contributor I
1,243 Views

I've compiled my project.  I've reserved an available pin for Signal Probe output.  When I try to Add Signal Probe Pin, the selected node is not found.  I see an error: Source node does not exist.  Please specify a valid nod.  I know the node exists since I can analyze it's behavior in Signal Tap.  The node is inside the Remote Update IP Core. 

0 Kudos
1 Solution
tedh4ddv
New Contributor I
1,193 Views

I changed node filter to post fitting and was able to select the target node.  The design compiled and the node was accessible at the selected pin.  Thanks for the advice.

View solution in original post

0 Kudos
3 Replies
sstrell
Honored Contributor III
1,227 Views

The signal probably got optimized away or renamed.  You were able to tap it in Signal Tap because you can tap pre-synthesis nodes.  Signal Probe only can connect to post-fit nodes, so they must "survive" the compilation process.

Either that or because it's a signal inside an IP, which sometimes can prevent post-fit access.

When you use the Node Finder to find the signal, are you using the Signal Probe filter?

0 Kudos
ShengN_Intel
Employee
1,211 Views

Hi,


You may also try confirming whether that node exists or not by click View > Node Finder, and filter by Signal Tap: post-fitting to view the nodes you can route. Check this link https://www.intel.com/content/www/us/en/docs/programmable/683819/23-3/step-2-assign-nodes-to-pins.html


Thanks,

Best Regards,

Sheng


0 Kudos
tedh4ddv
New Contributor I
1,194 Views

I changed node filter to post fitting and was able to select the target node.  The design compiled and the node was accessible at the selected pin.  Thanks for the advice.

0 Kudos
Reply